Selecting the “Input Number Button” allows you to enter a number from the ten-Įnter a correct number. (Make sure you have entered a correct number before you execute theįunction. If you enter an invalid number, a secondary problem will occur.) See the “dC330 Code List (Input), (Output)”, and enter an appropriate How to Enter/Exit the UI (IOT) Diagnostics ![]() ![]() You stopped the code from being executed. The combination of a code that has already been executed and the new code is You specified a cycle for the code that cannot be cycled. You stopped a code that is not being executed or displayed the status. Number of simultaneous executions exceeded 12 and you pressed Start. Input/Output display - Input: The count is increased every time the “High/Low Level”Ĭhanges. The maximum count is 256. After reaching the maximum count, theġ2 (Same as PWS). If the number exceeds 12, the oldest code is stopped.Ī warning message is displayed on the UI when the following occurs: UI Diag.: No module specification. All direct code specification. Component Control (dC330 UI Diagnostics), PrintĬhecks the Input/Output of each component by specifying the Chain-Link Number.įunctional comparison between the UI Diagnostics and the PWS Diagnostics:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |